Hello, I am new to the club. After my purchase of a rcd 971, I was sold on rotel. The 971 replaced a cal dx2. I recently purchased a rsp 1066 to replace a adcom gtp 860. My question is what power cord upgrade would work best with this unit ? Does anyone have any feedback ? Thanks, locorim.
-
hello all,
anyone has this pre-amp? i saw a deal on one for $600. no reviews at audioreview.com.
june16 August 2005, 13:29 Tuesday -
Based on some discussion in another thread, I went ahead and ordered a VH Audio Flavor 3 power cord to replace the stock cord that came with the 1066 pre/pro. However, when it arrived today, I noticed that the cord had a three-prong female receptacle with a three-prong male receptacle versus a two-prong... -
I need to purcahse a replacement power cord for a Rotel RMB-1066 Amp. Nothing wrong with the old power cord, I purchased it from an friend and the amp works fine. I tested it with the power cord from my Rotel RB-1050 amp. Any suggestions on where to find a replacement power cord? Thanks -
The power cord seems not to fit very snug in the back of my unit. It just seems to be loose, I've pushed as hard as seemed resonable but it just seems wobbley. Does anyone here find this as well? Also on a different note I have my PS2 hooked up via the ps multi cable so I'm only getting anlogue in.... -
I recently purchased a 1066 and a 1095 off of different people on Audiogon. While I am very pleased with both, I didn't find the 12 v trigger cord in the box. Is there a place I can find the cord online or order directly from Rotel? Turning on the 1095 separately is getting annoying.