ok on the back there are 4 plugs and i was wondering what does the HF and LF stand for? For now I have some crappy 60 dollar amp hooked up to it on the LF what is that??
-
-
Don't worry about that - the binding posts allow you to bi-amp or bi-wire, but the benefit of doing this is somewhat controversial. Just use the LF binding posts and make sure that that metal strip that runs between the upper and lower posts is not removed and you'll be fine.
Bill -
hehe thanks again!! I cant wait to get my rotel if it sounds this amazing on a 60 dollar amp I wonder what it will be like on the rotel =DComment
-
LF stands for Low Frequency...
HF stands for High Frequency...
And as wgriel said, for your application I wouldn't worry too much about it...
-JoeComment
-
I just added the RB1080 to my RSX1056 and it looks like I can hook up 4 speakers (I only want 2 naturally). Are the extra posts for bi-wiring? My cables are only bi on the speaker end. So... I don't hook up jumpers to the amp do I? Do the second set (left unused) just not draw power?
Th... -
Can someone enlighten me on the differences between simple and more complex crossover circuits? What is meant by n-th order cross-overs?
In addition, many (most?) 3-way and 2-way speakers have 2 sets of binding posts, not 3... Obviously, the specs state crossovers like 350Hz/4kHz for... -
Hello all,
I have a very noobi electrical question that I am hoping someone can shed some light on.
I successfully built a pair of Statement speakers a couple years ago (http://www.htguide.com/forum/showthread.php4?p=415052).
This was my first time using a soldering...
-
Hi!
I just wanted to pop in and let everyone know that I also have some Parasound equipment in my system.
I have the HCA 3500 (350w x2) John Curl design
and the HCA 2205 (220w x5)
These amps are an excellent match for my Paradigm Studios and I
couldn't be... -
Hi
I bought a demo Rotel RB-1080 last week to power my front speakers. As it is a demo unit, I did not get a manual with it. The unit has double binding posts on the rear panel.
My Dynaudio speakers does not have bi-terminals for bi-amping/bi-wiring. Does anyone know whether...
Comment