I think I recognize just about everyone here! Lex, you're quite the magnet -just stay away from my CRT unless you're properly shielded!
This has the makings of a great forum.
-Sili
This has the makings of a great forum.
-Sili
-
All I know about shielded drivers is that they minimize CRT picture distortion "but" also that they have somewhat differant T/S parameters than their faternal twin(non shielded sibling of same model). This naturally would call for some consideration when designing a crossover, but are there... -
Good news! OK, semi-good news...
PE has the RS 8 ohm non-shielded version AND all shielded version are on sale. I picked up four RS225s.
Are non-shielded version better than the shielded?
Are these drop replacements? -
Hi everybody. I know that dayton no longer produce shielded rs 225 but it ok for use the new rs225 without changing the crossover. Knowing, is it possible to mix shielded and non-shielded rs225 without changing the crossover ? I should have an opportunity of good price on 2 shielded rs225.
Thansk... -
Hi there, new member here.
I am thinking about changing my N805's for a pair of 805S's. I know that the N805's are shielded and that the 805 sigs are not. So, does anyone know if the new 805S's are magnetically shielded ?
thanks. -
I own three Dayton RS WTMW centers as mains. Something very bad has happened and i am forced to replace six RS225's and three RS150's. Can i just drop in unshielded drivers where shielded ones were.....Thank you
KG
Comment