Does the Signal flow arrow noted on audio interconnects has any influence ? can someone explain ?
Thanks !
Thanks !
-
-
The majority of the time it simply indicates the direction the wire is 'drawn' (pulled) through the forming die.
Sometimes it referres to a scheme where there is a lifted ground (drain ) wire at one end of shielded IC. This is called a telescoping ground.
In the case of the telescoping ground IC's yes pay attention to the arrows.
If the arrows are just indicating a wire draw direction just listen and see if you prefer one direction over the other.
theAudioWorx
Klone-Audio
IB subwoofer FAQ page
"Complicated equipment and light reflectors and various other items of hardware are enough, to my mind, to prevent the birdie from coming out." ...... Henri Cartier-Bresson
-
Just got a 1066 and I am having a problem with what I think is Ground Loop Hum. I have the unit hooked up to a Monster PowerCenter HTS-3500MkII which is plugged in to a grounded outlet with all of my other components. I then disconnected the other components leaving only this processor plugged in along... -
I've got the worst ground-loop noise thanks to my DishTV HD receiver... and I've tried almost everything I can to fix it. I'm *confident* it's from the Dish Receiver - as soon as I unplug the coax, the noise goes completely away.
Here's what I've done:
1. Bought a Ground... -
Thank You Very Much Direct TV!!! I upgraded (or should I say downgraded) from Dish to Direct TV. I bought a new 50" plasma and upgraded to HD. I knew that this was one of the first things I was going to be looking for after the installation.
Low and behold immediately after he...28 October 2005, 00:12 Friday -
Dear All,
Like many of you I had a ground loop problem caused by my cable TV connection. Via my dealer in India I was able to obtain a ground breaker (which he had imported from China). This ground isolator was based on breaking the ground connection using I believe windings much like... -
Good afternoon all.
I'm slowly but surely making progress on my Statement monitors.
The way I am doing the cross over is to have the mid/tweet on one piece of single sided FR4 and the woofer crossover on a second piece of single sided FR4.
The FR4 is drilled...
Comment