Does anyone know of any speakerbox and/or crossover modeling software software for macintosh osx?
-
-
IB subwoofer FAQ page
"Complicated equipment and light reflectors and various other items of hardware are enough, to my mind, to prevent the birdie from coming out." ...... Henri Cartier-Bresson
-
Hi All,
Working on my first DIY MTMs and wanted to begin by first confirming the measurement technique that should be employed.
I’ve read through the “Measurement Preparation with ARTA” document, but still have a couple of questions (included below). I think... -
I've been hankering to try a transmission line for a while. I realise many people use these for subwoofers and 3 ways, but I thought why not try it with a 2 way, using a low Qts driver to really make my job hard?
To make it even harder, why not throw an active crossover into the mix?... -
By Jon Hancock
This article will describe the fruits of my efforts to build a moderate sized speaker which might be moderately above average in performance for a basic two-way system. I desired a speaker like this both for my own use in secondary systems, and to fill a need for some friends, who desired fairly full range response (i.e., “it’s gotta have good bass”). Also, though I have access to a good wood shop, many potential DIY enthusiasts may not, so I hoped to use a modified...31 December 2024, 17:31 Tuesday -
Are there any competent FEM/BEM software packages available for the Mac OSX platform? I'm specifically interested in acoustic and electro/mechanical analysis.
I know Mige0 (diyaudio) has had great success with the AxiDriver software, however thats only available on Windows.
... -
I'm getting ready to build this project (already purchased all of the components and built the box) and was wondering if someone kind enough could please model the crossover and post the graphs and part values in this thread. This way other potential builder could use this information. Requirements...
Comment