Bi-amping...again

[DarrenR]

I'm going to do some experimenting bi-amping my B&W HTM-2 center speaker. Instead of hooking up a splitter from a single output of my processor, can anyone see a problem with plugging separate cables from the center 1 and center 2 outputs of my RSP-1066 into different amp channels, which would then feed into separate HF and mid/LF speaker terminal connections? I guess what I really am asking is whether the signal outputed from the center 1 and center 2 outputs of the RSP-1066 is exactly the same. Anyone tried this?

Darren

[Andrew Pratt]

That should work just fine

[GosonFletchy]

Yes, the signal is the same. It will sound very good. Just make sure that the amplification is the same for the highs and lows, preferably from the same amplifier too.

G :grab:

[DarrenR]

Thanks for the advice Andrew & GosonFletchy. Yes, I am using the same amp to drive HF & LF signals...I'll give it a try & report back the results.

Darren