Rotel 1050 Learning Remote Reset

[Club1820]

I know that you can reset the remote to factory default. But does this apply for all of the inputs at once or can it be input specific?

I would like to only reset it for Video 3.

Thanks in advance.

[Kevin D]

The PRELOAD button retores the remote to full factory specs, every input. You can use the CLEAR command to clear all functions under only one input (and it restores those factory functions when cleared)

Clearing Stored Commands
The CLEAR button erases learned commands from a single
button, all of the commands under a particular DEVICE
button, or a MACRO sequence.
1. Press the recessed CLEAR button with the point of a
ball point pen. A “CLEAR?” prompt appears.
2. Press a COMMAND button to clear a single command.
Press a DEVICE/INPUT button for less than one second
to clear the device selection code. Press and hold
a DEVICE/INPUT button to clear the input source selection
code. Press the MACRO button and then the
button where the macro is stored to erase a MACRO
sequence. A confirmation “OK!” appears in the display.

NOTE: When a learned command is cleared from a
DEVICE/INPUT button the factory original command code
is restored.

The RR-1050 automatically leaves the CLEAR mode if no
button is pressed for 15 seconds. Manually exit by pressing
the CLEAR button again.

[Club1820]

As always, Thanks Kevin!