Schematic
Hello. This Is My First Time On This Site, And Im Using It To See If I Can Get Some Repair Help For A Rotel Rsx-1067 Im Trying To Rebuild?.i Purchased Off E-bay From Someone Who Had It In Louisianna During The Great Flood. When I Received The Unit And Opened It , I Found Leaves In It And It Obviously Had Been Wet!!! I Believe That I Can Bring It To Life Again If Anyone Can Let Me Know Where I Can Get A Schematic And Or Where I Can Get Capacitors, Like 10v 3300uf/16v 1000uf/ 50v 22uf As Example.. I Dont Even Know If Im Allowed To Ask For This Type Of Help On This Site And Apologize; Hopefully Some Will Let Me Know As Well!!! Again The Unit Till This Date Is Sitting In My Room Waiting To Replace My Yamaha 5.1 Receiver. Ive Cleaned It Up Salvaged All The Parts I Could Except For A Few Capacitors.. Thanks For Reading..
-
-
Did you try the link to parts express on top of the page?
I had bought some caps and resistors from them once upon a time.
Or try digi-key, mouser electronics, or newark as they all carry various brands and sizes. -
Thanks For The Reply, Will Call Them For The Capacitors; You Think They Carry Schematics??
Comment
-
Being a current unit and only a few years old, I think you're going to have a really hard time findng some schematics.
Kevin D.Comment
-
Thanks For The Info. I Guess Ill Have To Do It With Out It. Will Post Pictures Of Unit When Done Reguardless Of Outcome.. Thanks Again.Comment
-
My Enermax 431 Watt supply recently died (too much hardcore OC I guess) I cracked it open to find some burst caps likely causing the problem. I need 1 x 3300uF, 10v, 12mm wide and 2x4700uF, 16v, 12mm wide. Anyone know where I can get some of these and don't have to order in large quantity? I have called... -
So I was lurking and came across a schematic I don't understand.
I don't know where the positive and negative terminals would go(source). Usually I would see a ground symbol(negative) and signal generator(positive). This schematic has a circle with 2 lines coming out for... -
I just finished building Dr. K's MTM (using the Dayton RS28a tweeter and RS180 midwoofer) from partsexpress.com -- I really like the sound. It is an improvement over the Dayton/VIFA MTM that was originally housed in my homemade 1.0 cu. ft. boxes.
Anyway, I am always hunting for my next... -
So, I am getting supplies together for a few new speakers but am trying to optimize performance and budget. Based on some reviews it looks like there may be some lower priced capacitors out there that seem to out perform for the price point. I just haven't seen anyone else mention these brands for use... -
Hello,
Who has for me a original schematic of a crossoverfilter from a B&W 640-i speaker?
Ther problem is that I change the original crossover components for much better components, but I have make a mistake in that and now I need an schematic from that crossover to...
Comment