RSX 1055 Voltage change (Help)

[hugexpat]

Hello
I own a RSX 1055.
I have to move back to France ( everything has an end..)

I have been told that the Rsx 1055 can be easily modified by switching some jumpers located in the left end corner (chassis opened)

I found the jumpers. There are three of them, two with the label 115 V with a strap in, and one in the middle without strap and labeled 230V.
( see picture attached)
Is there anyone aware about this change?

Do I have just to remove the two jumpers labeled 115V and plug the jumper 220V?

Thank you very much for your help
Hugues

[Kevin D]

I would contact Rotel Europe if you haven't. But they will probably tell you to bring it in.

Kevin D.

[hugexpat]

Yes Kevin,
I have emailed my question to Rotel Europe. I do not know whether they will answer or not, but betting on the reputation of Rotel I hope so.

I follow the Club Rotel forum for months now and noticed several european subscribers.
This might be my chance. One of them may have an idea about the voltage "jumpers thing", or might have opened already their 1055 chassis and remembered the jumpers position...

I crossed my fingers..
Thank you
Hugues

[Kevin D]

I sent you a PM earlier today in case you didn't see it. Hit the 'private messages' link on the upper right of the page.

Kevin D.

[sirbogey]

Hello
I own a RSX 1055.
I have to move back to France ( everything has an end..)

I have been told that the Rsx 1055 can be easily modified by switching some jumpers located in the left end corner (chassis opened)

I found the jumpers. There are three of them, two with the label 115 V with a strap in, and one in the middle without strap and labeled 230V.
( see picture attached)
Is there anyone aware about this change?

Do I have just to remove the two jumpers labeled 115V and plug the jumper 220V?

Thank you very much for your help
Hugues

I missed your message by couple of weeks. I had 3 pages of instructions directly from Rotel Europe. But I threw them away, 'cause I sold the RSX1055 12 months ago...