1068 pop's then no sound.......HELP?

[TimGRA]

I have a 1068 w/ Parasound 2205 amp. The speakers pop / thud and then there is no sound. I then turn off the 1068 and immidiately turn it back on and the sound is back. I have already checked the following
1. Cables are good and not touching
2. Turned off triggers to be sure it was the 1068 when the sound went away.
3. Honestly I have checked everything.

A little frustrated becuase last year the center channel went down at the Holiday
Sound familiar to anyone?

[PewterTA]

Has it only done this one time or has it done it multiple times?

Could have been a power surge or something strange that caused it...

If you weren't moving wires at the time, it's possible something touched and shorted the connection, but more unlikely. I know I have a ground issue somewhere with one of my cables because my back right speaker pops whenever a relay in my 1098 switches. It's a minor annoyance, but I think it's one of my Cat Cables. :unsure:

[TimGRA]

I just spoke with Mike @ Rotel and I will be sending it in to them. He thinks it is a bad relay.

Thanks for the help.

PS. The service from Rotel and particulairly Mike, has always been tremendous. I whish I could say the same about my local dealer. That is the reason I will be sending it to Rotel.

MERRY CHRISTMAS!

[Kyle]

I just spoke with Mike @ Rotel and I will be sending it in to them. He thinks it is a bad relay.

Thanks for the help.

PS. The service from Rotel and particulairly Mike, has always been tremendous. I whish I could say the same about my local dealer. That is the reason I will be sending it to Rotel.

MERRY CHRISTMAS!

Can't agree more Tim, Mike is very helpful. I wish I could send my equipment directly to Rotel everytime I ran into a problem

[randyman]

Tim,

Your local to me. Which local dealer is giving you problems?

[TimGRA]

Freds