Hi again guys, looks like I am going to have some time on my hands waiting for my preamp to get fixed so now I am pondering my next purchase.
I am considering using 2 RB1070 amps bridged to power my front speakers.
That should produce about 330 wattts per channel.
However, there is also the RB1080 which does 200 watts per channel unbridged.
Which set up would be best? The costs of each setup would be similar. Anyone tried this out?
I know that distortion level are usually higher with bridged amps, but from what i can gather nobody can tell the difference as long as the distortion levels are below a certain level. Is this correct?
My speakers are rated at 250 watt @ 8 Ohm with 91 -94 db sensitivity.
Any thoughts or info would be helpful.
Also anyone know of any specs or reviews on the 1070 amp when bridged?
thanks Pete.
I am considering using 2 RB1070 amps bridged to power my front speakers.
That should produce about 330 wattts per channel.
However, there is also the RB1080 which does 200 watts per channel unbridged.
Which set up would be best? The costs of each setup would be similar. Anyone tried this out?
I know that distortion level are usually higher with bridged amps, but from what i can gather nobody can tell the difference as long as the distortion levels are below a certain level. Is this correct?
My speakers are rated at 250 watt @ 8 Ohm with 91 -94 db sensitivity.
Any thoughts or info would be helpful.
Also anyone know of any specs or reviews on the 1070 amp when bridged?
thanks Pete.
Comment