I am new to this site, I have done searches and found nothing on my question, so here goes. I have just bought a new b&k rf 50. I want to know if any one can give my a straight answer on the notch equalization. I called b&k, they said look at the rf 50 s2 manual. my room is 20 x 20 if that helps. I just want a starting point and what I am looking for with this. Thanks.
-
-
pm'd you some info on it -
WHat the Notch filter does is it tames a group of Freq's in the lower end. It has an adjustable sweep you can test your room with. The output is -30hz. This is great and can really help your room response.
First thing before you sweep your room is properly calibrate the system with an SPL meter. You will also need your SPL meter when setting up the notch filter.
If you need more help on how to do it, let me know and I can walk you.
DanComment
-
I belive I did it right. I use my spl and at the lower freq's I set my spl on 80 and went through the lower hz and flatend out the higher db. I only have one on the ref50 s1, as were the s2 has 3 settings. I belive I have to go through it again. Maybe this time I'll try to inverse the sub to see what that does. Do think I'm going in the right direction.ThanksComment
-
please guy i need to know if i can make it work well i have 3 meter X 4 meter room, and 804 di and i would like to add this sub..
will it be good? its not too much 2X12"? -
Hello all -
I thought I would start a thread about my dabblings with the EQ function built into the SSP-800. I was going to hire an acoustician to calibrate the EQ for me, but I’ve recently decided to give it a go my self. I’ve been playing with EQs for the past few years, so I’m... -
I've heard it said multiple times that frequency response and waterfall charts contain the same information, and they're just different ways of looking at the same thing, which is the impulse response. Now I know both are derived from the impulse, but are they mathematically equivalent? Meaning you... -
I'm a newbee here and this is my first post. Since I am primary considering Rotel gear, I hope I'm posting this in the right place.
I need some advice for you professionals / experts out there. I’m in a bit of a jam. Not that I need to rush this but my theatre is being installed... -
Today, I tried to measure my room response using the Radioshack analog spl and the Rives test cd. Before doing this, I honestly thought that my room was ok, I probably had some bass issues but that was it. Boy was I wrong!!! I plan on doing this test again since this was my first time but if this...
Comment