Hi! Just wanted to get some opinions on the above mentioned amps. They are both 250wpc but one is 2 channel the other is 5 channel. If you drive the same speakers with either one which combo would you think is better? And why.
-
-
Anyone? -
You might try asking this over in the Rotel forum.
I would guess that the choice between these two would depend on whether you want to drive 2 speakers or 5!
If you are wondering if you get any performance gain with the 2 channel amp over the 5 channel amp when listening in Stereo, I couldn't say for sure. But I'd guess that the difference would be quite minimal.Comment
-
Thanks, will do.Comment
-
Hi there,
I currently have a Sony 5300 es amplifier with b&w 683's for fronts, htm61 for center and 602 s3 for rears. I use the front and SB channels to drive the fronts in the so called sony bi-amp config. The 683's are a bit too hungry for my amplifier and im consudering buying... -
I have the following HT setup :
RSX-1056
RB-1070 for front channels
RMB-1075 for center, surround and back channels
B&W DM603 S3 Front
B&W LCR600 center
B&W DM602 S3 surround
B&W LCR600 center back
B&W ASW-600 sub
... -
I have a Rotel RMB-985 multi-channel amp that I'm using as a secondary amp in a different room. All channel's work except for the right channel which doesn't produce a signal. I'm using it with a Rotel RSP-1069.
I've been able to work around the problem by using the right surround... -
Hi! Just wanted to get some opinions on the above mentioned amps. They are both 250wpc but one is 2 channel the other is 5 channel. If you drive the same speakers with either one which combo would you think is better? And why. -
Can anyone tell me please what the power output is of these amplifiers after 4ohm?
I understand they are 250w into 8ohm, 500w into 4 ohm...............?
My speakers dip down to 3.6ohm, and im curious as to whether my 1575 is sufficient for them.....it certainly sounds good?...
Comment