Hi guys.. I noticed that sometimes there is peoples who like to check FST Screw tension on 800 series.
Here is the correct answer.. And dont use screwdriver use a coin..
"Dear Darko
The correct tension is carried out at the factory and should not need any adjustment.
The tightness of the screw is not as critical as on the original 800 series, if they are "finger tight" this should be fine.
If you want to be exact, the torc should be set at 2,5Nm +/- 0.1Nm
Regards
B&W Group Ltd"
Greetings
Darko
p.s. Off topic: I just got HTM3S And i have a problem since start.. It's too heavy so i'm waiting for a friend to help me to get it inside my place I'll share my impression after few days..
Here is the correct answer.. And dont use screwdriver use a coin..
"Dear Darko
The correct tension is carried out at the factory and should not need any adjustment.
The tightness of the screw is not as critical as on the original 800 series, if they are "finger tight" this should be fine.
If you want to be exact, the torc should be set at 2,5Nm +/- 0.1Nm
Regards
B&W Group Ltd"
Greetings
Darko
p.s. Off topic: I just got HTM3S And i have a problem since start.. It's too heavy so i'm waiting for a friend to help me to get it inside my place I'll share my impression after few days..