How do you replace a tweeter diaphragm on a Matrix 801?
-
-
It is very easy. First of all you must take out the midwoofer and then the tweeter and his connector. Unscrew the 2 screws at the tweeter, screw the new diaphragm and place the connector. :TOriginally posted by DM3000 Owner -
This is for the Matrix 3. I spoke to B&W and they said that it needs to be soldered. This is just the leads and should be very easy. Any thoughts?Originally posted by foruuComment
-
Yes, this is for the Matrix 801 S3.Comment
-
In the thread 'How to replace tweeters on Nautilus and Signature speakers' DM3000 Owner answered my question about replacing tweeters on the Matrix 801 S3 (and S2) as follows:
"I did a Matrix tweeter....
You can do it two ways. Both require removing the tweeter housing.
01 January 2011, 09:05 Saturday -
I just replaced my CM-4 tweeter diaphragm and thought others may benefit from my experience.
Here are my modified directions from Eric at B&W on how to disassemble the tweeter:
1. Remove grille, remove the 6 silver posts that the grill attaches too. Simply unscrew these...04 November 2009, 10:59 Wednesday -
Buddy has Matrix 803 with bad tweeter and can get tweeter diaphragm for it
Apparently its a solder type which means the leads are likely
Anybody have swap out procedures on done it before, shouldn't be to hard-+ -
Hi,
I need to install a new tweeter for a Matrix 801 S3. I do have a new tweeter at hand but I am not sure how to install it.
How do I get into the tweeter house?
I hope someone can help and if so please let me know the steps I have to take to change the tweeter.
... -
Hi everybody!
As many of you, the Matrix 801 were a dream from the very beginning, when falling into Hi-Fi clutches. Years have passed and finally I could bought a pair of 801 Series II second handed (white ones), while now I also got another pair of 801 (black ones), but in Series III....
Comment