OK, here is the deal. I have a set of DIY 6.5" w/dome WTW (or MTM if you prefer) speakers with subs that sound fairly good. However w/o the sub, they lack bass and punch. With the subs the bass is a bit muddy for music.
I want smooth, clean sound with punch when required. So a large set of floorstanding speakers are in order.
I was thinking about the following:
a) 2ea woofers in a 4 Ohm config (I like sealed!) maybe 12's maybe 15's, muddy is not ok.
b) 2ea midrange, not sure if I want 5.5 mids or dome mids.
c) 1ea dome tweeter, silk or metal is OK as long as it is not harsh.
d) No horns of any type!
e) I desire flat response well into the very low freq's.
f) 5cf enclosure is OK with me, but not too much larger.
I took a look at the PE Magna Cum Laude design, but the drivers may be a bit low end for my tastes. While cost is a factor, I do not mind spending more for good, clean sound and reliability.
I would consider other options such as 4ea 8's or 4ea 10's.
Here is where I need your advice:
1) Should I use mid range 5.5" (or similar) cone drivers or a dedicated dome (or other type) midrange driver crossed over a bit higher?
2) Does a large number of midrange drivers have a negative effect on sound quality?
3) Same question for tweeters?
4) Are automotive small sealed box type subs worth considering?
5) I have read that lower Xmax drivers sound better, true?
6) Can some of you suggest drivers?
7) Using 4ea smaller woofers might allow a higher crossover point to the mids, is this worthwhile?
8) Any other suggestions would be welcome!
I have the skills and tools necessary for the construction. However I do not have a degree in "speaker engineeering".
Thanks!
Chris
I want smooth, clean sound with punch when required. So a large set of floorstanding speakers are in order.
I was thinking about the following:
a) 2ea woofers in a 4 Ohm config (I like sealed!) maybe 12's maybe 15's, muddy is not ok.
b) 2ea midrange, not sure if I want 5.5 mids or dome mids.
c) 1ea dome tweeter, silk or metal is OK as long as it is not harsh.
d) No horns of any type!
e) I desire flat response well into the very low freq's.
f) 5cf enclosure is OK with me, but not too much larger.
I took a look at the PE Magna Cum Laude design, but the drivers may be a bit low end for my tastes. While cost is a factor, I do not mind spending more for good, clean sound and reliability.
I would consider other options such as 4ea 8's or 4ea 10's.
Here is where I need your advice:
1) Should I use mid range 5.5" (or similar) cone drivers or a dedicated dome (or other type) midrange driver crossed over a bit higher?
2) Does a large number of midrange drivers have a negative effect on sound quality?
3) Same question for tweeters?
4) Are automotive small sealed box type subs worth considering?
5) I have read that lower Xmax drivers sound better, true?
6) Can some of you suggest drivers?
7) Using 4ea smaller woofers might allow a higher crossover point to the mids, is this worthwhile?
8) Any other suggestions would be welcome!
I have the skills and tools necessary for the construction. However I do not have a degree in "speaker engineeering".
Thanks!
Chris
Comment