A lot of the madisound inductors don't have a resistance listed (the 16 ga sidewinders, at least). How do I calculate the resistance of each? I'm building Mark's RS225 in a floorstander, and I can't find any inductors with the right values, which led me to the ones that don't have resistance listed.
-
-
See this PDF...
http://www.madisound.com/pdf/sh_sl_sw_coils.pdf
-
guys, i've had my rs tmww towers built for about a month, and just got money to order crossovers and drivers. The problem is that parts express is out of .40mh inductors (both kinds they offer) parts 266-814, 255-224
and i've been watching they keep pushing back the date, this is the... -
Does anyone have experience with the 10 awg or 12 awg air core inductors from Solen? I am wondering if they are a good substitute for foil inductors, as the resistance is about the same. Also, they are a little cheaper. I've personally iused an air core inductor larger than 14 awg. I've always used... -
Hi all, this is my first post on this very informative forum.
How it all started: searching for a strange distortion in my mid driver i heard interference from my bass inductor (iron core) ending up in my mid speakers via the parallel notch inductor (iron core) of the mid speakers. ... -
Hi,
I’m embarking on my journey into the world of DIY speakers, by building a set of the Jim Holtz statement speakers, starting with the centre speaker. I’ve done a bit of woodworking in the past, and have a degree in electrical engineering, but that was a long time ago, and I’m... -
I am using some C-Coil inductors from Jantzen for my Modula TMM build. Them, along with every other inductor and part get measured prior to using them in my crossover. Every other inductor i have measured in the past ends up being ever so slightly above the stated inductance, which is great because...
Comment