1068 problem - power standby/on

[ariches]

I've had my 1068 for about a month now. I leave the master power switch on the back on at all times. But several times when using the remote to switch from standby to ON the blue/violet light goes OFF and nothing else happens (the display stays blank) and repeatedly pressing the standby button on the front has no effect. I have to physically turn the master power switch at the back off and then on again to reset the unit. This has only happened three times in about 5 weeks but does anybody know what might be the cause. Thanks.

BTW Software version is 1.2.2

[pbarata]

Don’t want to fright you, but I had the same problem with my RSP-1066 and one day it didn’t power up, the main processor board broke.

Just look at

http://www.htguide.com/forum/showthread.php4?t=13420&highlight=rsp-1066+died

there are same procedures you can take to diagnose better your problem.

Or simply your setup makes the unit goes to standby mode after a power up.