Profigold Cable Direction pre/power amp
Profigold 3000 phono leads have an arrow on them. Any idea what direction it should go from 1068 to 1075?
:B :lol: -
Hi all,
(New to the forum, so not sure if this post is in the proper place.)
I have some Transparent Link 200 cables that connect my pre/pro to my amp.
My (silly) question is this, what side does the `bump' go on? Eg, is the bump supposed to be closest to... -
Well after spending most of my evenings reading posts on this site I finally made the plunge.
RSX 1055
RMB 1075
Fronts- Nautilus 803s
Rears - Nautilus 805s
I have not used all of my budget yet, so I am looking at getting a Nautilus center channel and not sure yet... -
I have a pair of B+W Matrix 802 Series3 speaker which are powered by Rotel RSP-1068 pre-amp and Rotel RB-1080 2ch power amp, I'm concidering upgrading the speaker cable (2x4m Bi-Wire) and was hoping someme could guide me in the right direction. I presuming quite a few of you have similar equipment,... -
This is the third upgrade I've done. My original cable was just a cheap USB cable I got from who knows where and it worked sounded good and no complaints.
This all going to my Musical Fidelity V-Link 192.
Then I upgraded my usb cable to a Wireworld Ultraviolet cable and... -
hi,
Pls see my room layout attchd with dimensions. The height of my room is 9.5 ft and I cannot change the layout much except for bringing the TV to the left slightly so that its more in line of sight with the Sofa. I will leave 20%(as suggested by an acoustic engineer) of the total length...
Comment