I have a 1098 and trying to use a Buffalo IR extender with the IR in on the back of the 1098. Using a xantech 3.5mm mono cable from the buffalo to the 1098 and it seems as though the 1098 isn't recieving the IR signal about 70% of the time, it works about 30% of the time - however if I use an IR blaster from the Buffalo to the IR receiver on the front of the 1098 it works 99% of the time. Running an old version of the firmware (1.2) and been too lazy to update - any thoughts??
1098 IR problems
Collapse
This topic is closed.
X
X
Comment