Hello everyone
A few weeks ago I upgraded my firmware to version 1.05. Everything was fine (got my most wanted fix of 24/192 over SPDF), but few days later I wanted to check the status of my CA 2200 and soon as I pressed status and CA 2200 option 3 options would be selected at once - (operate, global stand by, global dim) - amp goes to protection mode - right away.
Got to try it with my new CAM 600 and the same thing happens, (3 options are selected at once), except that it does not go to protection but blue-red light is flashing.
I would appreciate if you guys could test that with your CP 800 and let me know please if you have the same problem?
Thanks
Sasha
A few weeks ago I upgraded my firmware to version 1.05. Everything was fine (got my most wanted fix of 24/192 over SPDF), but few days later I wanted to check the status of my CA 2200 and soon as I pressed status and CA 2200 option 3 options would be selected at once - (operate, global stand by, global dim) - amp goes to protection mode - right away.
Got to try it with my new CAM 600 and the same thing happens, (3 options are selected at once), except that it does not go to protection but blue-red light is flashing.
I would appreciate if you guys could test that with your CP 800 and let me know please if you have the same problem?
Thanks
Sasha
Comment