guys,
i bought the Denon AVR 1909 and have a couple of questions.
1. There is only one LFE output on the back to connect up a powered sub and was wondering if this could be split in two without adversly affecting that signal? i am looking at building a Sonotube sub to hit the real lows in a HT setup and would like tro keep using my existing velodyne that is tuned a little higher in the LF range at the same time.
2. the impedence rating on the Surround (6-12ohms) and Surround back (12-16ohms) is concerning me. i am building surround speakers (RS150MT rated at 8ohms due to the woofer being 8ohm) that look like they will work for the surround channels but not the surround back. what will the impact be to my amp/speakers if i build the same type of speakers for the surround back that i am building for the surrounds?
thanks for looking guys.
i bought the Denon AVR 1909 and have a couple of questions.
1. There is only one LFE output on the back to connect up a powered sub and was wondering if this could be split in two without adversly affecting that signal? i am looking at building a Sonotube sub to hit the real lows in a HT setup and would like tro keep using my existing velodyne that is tuned a little higher in the LF range at the same time.
2. the impedence rating on the Surround (6-12ohms) and Surround back (12-16ohms) is concerning me. i am building surround speakers (RS150MT rated at 8ohms due to the woofer being 8ohm) that look like they will work for the surround channels but not the surround back. what will the impact be to my amp/speakers if i build the same type of speakers for the surround back that i am building for the surrounds?
thanks for looking guys.
Comment