HI. I have been lurking for quite some time and have finally started my project. I am starting with the Center and then will go on to do the monitors. I have all the parts except the tweeter (should be here Monday) and am almost done with the cabinet. Here are picture of the cabinet and the cutouts in the back panel and the layout for the front baffle. I hope to tomorrow to cut out the front baffle. A qusetion on the front baffle. What is the best way to open up the back of the cutouts? I have seen a couple of different ways. Is the router bit the best? If so I need to get one and not sure of the size and what it is called. I also need to get a flush bit and am not exactly sure of what to get as they have all different sizes.
JS
JS
Comment