I discovered the Black and Decker Rota-Driver at Home Depot. What a great idea for drilling/screwing in tight areas! I wanted to share with you other DIY-ers. Installing the crossover boards into the back bottom of monitor speaker cabinets is a pain. I screw down the four corners of the board into the cabinet bottom, which means that sometimes I'm in there at the corner intersections at the back of cabinets. It was tough even with my Milwaukee cordless screwdriver, but this new B&D baby, with its rotating collet gets a bit right up into the corners of the workspace. It was $29+ and worth it.
A real "why didn't they make this tool before?"
Collapse
This topic is closed.
X
X
-
yep, those are pretty nice for the price. I ended up getting this instead:
Bosch Power Tools – Trade/Industry. The professional blue power tools from Bosch are engineered for excellence – meeting the highest standards in speed, precision and robustness for great, professional work results.
It's nowhere near as inexpensive, but has 2 batteries and a 30min charger so by the time one battery is dead, the next is ready to go. You can get it in very tight places and the handle rotates to get different angles. Has lots of power and the clutch starts slow and works up to speed so the bit doesn't slip off screws. I recently used it to put in screws for drywall. I was able to put in well over 100 1-5/8" drywall screws on a single battery.
John- Bottom
-
Nice - if I were a pro, I'd consider one of those.
I was just suggesting an inexpensive tool for casual DIY-eers, not for pro's or cabinet makers. It gets further into tight corners than anything I've seen, including the new "compact" LI battery jobs at HD.- Bottom
Comment
-
Another alternative is to put rubber adhesive 'dots' at the four corners and just put a screw through a pre-drilled hole in the middle of the XO board for a screw to tension the board down against the rubber dots (which kind of act like stand-offs).- Bottom
Comment
-
If you say that's because vibrations would affect the crossover, we're going to have to have a discussion Hank- Bottom
Comment
-
Originally posted by AmphiprionIf you say that's because vibrations would affect the crossover, we're going to have to have a discussion Hank- Bottom
Comment
-
Now now, we can't talk about that except in PM's. And I can't mention I might have to cancel because of a possible party hosted by a hot blonde PhD student at A&M that I went on a date with last weekend- Bottom
Comment
-
I actually think I'm giving up the plasma tweeter project, at least for now. The hazards involved and the very, very limited success have me re-evaluating the endeavor. I also blew up the board two days ago (haven't debugged it yet) but the circuit breaker and GFCI don't like it when I plug it in anymore.- Bottom
Comment
-
Originally posted by AmphiprionNow now, we can't talk about that except in PM's. And I can't mention I might have to cancel because of a possible party hosted by a hot blonde PhD student at A&M that I went on a date with last weekend
(we all know what the Project is. )- Bottom
Comment
Comment