Since there isn't a published BOM (or a build thread here that I can find) for the Microbe SE, can anyone verify that this BOM I put together based on Roman's site is correct? My total comes out higher than others I have seen on this forum, but I'm not sure why. The 1.8 mH inductor seems awfully pricey, but seems to be what Roman is calling for in the wiring diagram if I'm not mistaken...
QTY PE PN Description Unit $ Ext $
2 295-360 RS125S-8 21.85 $43.70
2 Seas 22TAF/G 27.45 $54.90
2 027-418 3 uF capacitor $1.67 $3.34
2 027-422 4.7 uF capacitor $1.89 $3.78
2 027-425 5.6 uF capacitor $2.10 $4.20
2 255-028 20ga 0.3 mH inductor $3.24 $6.48
2 255-428 15ga 0.42 ohm 1.8 mH inductor $19.26 $38.52
2 255-200 18ga 0.05 mH inductor $2.26 $4.52
2 004-6 6 ohm resistor $1.38 $2.76
2 004-7 7 ohm resistor $1.38 $2.76
Subtotal $164.96
Thanks in advance! These, along with the RS150 MTM center and Modula MT R/Ls will be my first crossovers built from scratch and I want to make sure I order the correct parts.
QTY PE PN Description Unit $ Ext $
2 295-360 RS125S-8 21.85 $43.70
2 Seas 22TAF/G 27.45 $54.90
2 027-418 3 uF capacitor $1.67 $3.34
2 027-422 4.7 uF capacitor $1.89 $3.78
2 027-425 5.6 uF capacitor $2.10 $4.20
2 255-028 20ga 0.3 mH inductor $3.24 $6.48
2 255-428 15ga 0.42 ohm 1.8 mH inductor $19.26 $38.52
2 255-200 18ga 0.05 mH inductor $2.26 $4.52
2 004-6 6 ohm resistor $1.38 $2.76
2 004-7 7 ohm resistor $1.38 $2.76
Subtotal $164.96
Thanks in advance! These, along with the RS150 MTM center and Modula MT R/Ls will be my first crossovers built from scratch and I want to make sure I order the correct parts.
Comment