I have 4 Dayton DA175 and 2 Seas 27TBFCG that I'm using in Zaph Audio's BAMTM. I just have 2 wiring questions before I break something...
There are no +/- marks on either the woofer or tweeter. Is there some trick to determining which terminal is which or can I just connect the wires to either?
Also, I believe I'm wiring the woofers in parallel, so can I just run 2 separate wires off of the crossover to each separate woofer, or would you suggest just running one wire off and then continuing it to the next woofer?
I.E.
[+ X-Over]-----------0---------0 (one continuous wire)
[+ X-Over]-----------0 --------0 (2 separate wires)
********\ _ _ _ _ _ _ /
Thanks
There are no +/- marks on either the woofer or tweeter. Is there some trick to determining which terminal is which or can I just connect the wires to either?
Also, I believe I'm wiring the woofers in parallel, so can I just run 2 separate wires off of the crossover to each separate woofer, or would you suggest just running one wire off and then continuing it to the next woofer?
I.E.
[+ X-Over]-----------0---------0 (one continuous wire)
[+ X-Over]-----------0 --------0 (2 separate wires)
********\ _ _ _ _ _ _ /
Thanks
Comment