I am making the Zaph B3S design and as part of the design, I had to unwind a .1 mH coil down to a .08 mH.
so now the end of the wire on the coil is not the nicely factory stripped and tinned end, but epoxy coated wire.
I sanded the end with emory cloth before soldering, but I am not sure that I really got the job done (or how to tell really).
does anybody have a recommended procedure for stripping the coating in this situation?
so now the end of the wire on the coil is not the nicely factory stripped and tinned end, but epoxy coated wire.
I sanded the end with emory cloth before soldering, but I am not sure that I really got the job done (or how to tell really).
does anybody have a recommended procedure for stripping the coating in this situation?
Comment