I am finally at the last stages of my version of ThomasW’s Tubezilla with 2 Avalanche 15 drivers and 180 liters of total tube volume.
I am wondering what is the recommended way to wire them?
I intend to have only one set of binding posts. Each driver has 2 terminals that measure about 2 Ohm each. My amplifier of choice is Behringer EP2500.
Should I wire the terminals of each driver in series and then parallel two drivers? Or should I series everything and get 8 Ohm total? The EP2500 will do 1500Watts into 8 Ohm, which seems to be fine for 2 Avalanches.
Anyway, any suggestions are appreciated.
Victor
I am wondering what is the recommended way to wire them?
I intend to have only one set of binding posts. Each driver has 2 terminals that measure about 2 Ohm each. My amplifier of choice is Behringer EP2500.
Should I wire the terminals of each driver in series and then parallel two drivers? Or should I series everything and get 8 Ohm total? The EP2500 will do 1500Watts into 8 Ohm, which seems to be fine for 2 Avalanches.
Anyway, any suggestions are appreciated.
Victor
Comment