I just finally made my mind on what project to build. I chose those DA-175 because of their good bass.
I just posted a thread on parts-express.com board and go no answer to my cabinet question...
I have the driver selection, and the crossover schematics, (thanks to M. Jakubin). I have tried many of the cabinet design softwares suggested here and there on DIY websites, but since I am a newbie, I just don't understand the recommendations they give.
Here is the link for the crossover schematics. I think it has been designed by M. Pete Schumacher.
Here is the link for the T/S parameters for the DA175 driver.
here is the link for the T/S param. for the Hi-Vi K1
What I want is a floorstander, the volume isn't a problem. I also don't wan't to use a subwoofer so I would like a vented cabinet that produces good bass.
My 2 questions are:
1- Anyone has a plan for the cabinet? Precise plan, telling where to put braces, the height of each driver, the exact size and configuration or the port (tube), et...
2- Where do you find inductors of 1,2 mH that are .11 Ohm? (same for the other inductors of the xover) I could'nt find the on either partsexpress.com or madisound.com. Or is the Ohm value not important? I don't know anything in that electronic stuff
I just posted a thread on parts-express.com board and go no answer to my cabinet question...
I have the driver selection, and the crossover schematics, (thanks to M. Jakubin). I have tried many of the cabinet design softwares suggested here and there on DIY websites, but since I am a newbie, I just don't understand the recommendations they give.
Here is the link for the crossover schematics. I think it has been designed by M. Pete Schumacher.
Here is the link for the T/S parameters for the DA175 driver.
here is the link for the T/S param. for the Hi-Vi K1
What I want is a floorstander, the volume isn't a problem. I also don't wan't to use a subwoofer so I would like a vented cabinet that produces good bass.
My 2 questions are:
1- Anyone has a plan for the cabinet? Precise plan, telling where to put braces, the height of each driver, the exact size and configuration or the port (tube), et...
2- Where do you find inductors of 1,2 mH that are .11 Ohm? (same for the other inductors of the xover) I could'nt find the on either partsexpress.com or madisound.com. Or is the Ohm value not important? I don't know anything in that electronic stuff
Comment