This is where I'm at with my Kharma-inspired speaker. Front, rear baffles are 1 1/8" mdf. Side walls are 3/4" mdf/felt/1/2"mdf/1/2" carpet padding. Cabinet is tilted 5 degrees back. Woofer section is 1.6cf and is sealed off from mid/tweeter. Midrange in a sealed and damped 1.4L container. X-over for woof will be on the bottom and mid/tweet in top cabinet.
Drivers I had chosen are Seas H1212, H1262 and H282. I am considering changing drivers. (I know, holes made already, kinda limits me). Flange diams' are 8.5", 5.75" and 4.08" so nothing smaller. Any suggestions will be appreciated (except for that $460 Accuton midrange :nutkick: .)
I'm at a point in my construction where I have to make a design decision.
I originally was going the Kharma "Exquisite" route but now I'm liking the "Ceraminique" look (no wood). Also how to finish the edges. I'd like to do a large handrail roundover but my 1/4" collet says "eh-eh". I may do it by hand anyway if I feel like Michelangelo one of these days.
Any suggestions on any of these things would be great.
Drivers I had chosen are Seas H1212, H1262 and H282. I am considering changing drivers. (I know, holes made already, kinda limits me). Flange diams' are 8.5", 5.75" and 4.08" so nothing smaller. Any suggestions will be appreciated (except for that $460 Accuton midrange :nutkick: .)
I'm at a point in my construction where I have to make a design decision.
I originally was going the Kharma "Exquisite" route but now I'm liking the "Ceraminique" look (no wood). Also how to finish the edges. I'd like to do a large handrail roundover but my 1/4" collet says "eh-eh". I may do it by hand anyway if I feel like Michelangelo one of these days.
Any suggestions on any of these things would be great.
Comment