Tesla Vacuum Tube factory tour......
Courtesy of Mikey at Stereophile....
Courtesy of Mikey at Stereophile....
-
Hey everyone.
First off let me say how awesome Jed is. I happen to be fortunate enough to live within about 15 minutes of Jed and already have a set of the R44 speakers he designed. Jed helped me with the carpentry work that I do not have the tools to do well enough without massive tolerances.... -
Rotel has a new verison of the RSP-1098! About 1 month ago my 3 month old 1098 was having problems so my dealer asked rotel to ship them a replacement unit. When I got it home (I still had the old unit hooked up) and took it out of the box I noticed on the back panel that all the S-Video inputs were... -
Any recommendations on how to ship a pair of 803 speakers? I am currently planning on going with Fedex Freight. Due to their height, I feel they could tip over. Unlike LCD/Plasma TVs, I assume these speakers can just ship on their sides....? Who have you gone through that you'd go through again... -
I have a few ideas on how I'd like to ship some 48" tall, 9" wide, by 15" deep speakers, but I thought I would hear from you all to see if there are some really affordable ways to get the job done efficiently. Suggestions?
Would you ship them separately?
Would... -
Loudspeaker T/S often includes only a single Le value for inductance, however driver motors are usually much more complex than a single coil of wire, so Le on its own is not a very good description of the driver characteristics. An extended impedance model, or “semi-inductance” model can provide additional characterization of the impedance curve for greater accuracy.
Many Scan-Speak drivers include this data in the “advanced parameters” section of their datasheets, however the...26 December 2022, 14:07 Monday