........ANY EXPERIENCE WITH THE ABOVE SPEAKERS IN ACTIVE BIAMPING MODE IS VERY MACH APPRECIATED..
THANKS
sangel@ote.gr
THANKS
sangel@ote.gr
-
-
Yes. I'm using a Bryston 10B crossover with Bryston 7B-ST's on the bottom and (currently) AR VS-110's on top. The low pass is set to 18db/octave @ 250 Hz, and the high pass at 6db/octave @ 200 Hz. I also use a pair of Vandersteen 2Wq's with an in-line passive crossover set to approximately 65 Hz first order.Q.
-
Just received my 804's but have not hooked them up yet. I'm contemplating biamping them versus single wiring. Does anyone have an opinion on biamping? I've read in multiple posts that biwiring doesn't do much in terms of an audible difference but biamping can due to isolated current to the high and... -
I'm looking into actively biamping my stereo setup, meaning adding an active crossover after the preamp so to send just 350 Hz and up to a tube amp and into the mid/hi posts in my 804S, send only 350-50 Hz to a SS amp and into the woofer posts in the 804S, and send up to 50 Hz to my REL Storm III sub... -
I know not many here run active systems, but I thought I'd share this since Jon is probably one of the few who can shed light on the causes of the differences I heard.
So I've been working on some small TM's for the last year and finally came to a place where I was happy with the voicing... -
Here is challenge for Mark H. or Jon M. I've been looking at the Behringer XO's and after recurring comments about reliability and possibly less then stellar SQ on the forums I'd like to see if you guys can design a simple active XO with high quality parts/execution/design that us diy'ers could build....
-
I've been trying to get up the guts (and money!) to build a home theater system. I want to start with just the front channels now and worry about the surrounds and subwoofer later. I'd like to go active and have been bouncing some ideas around in my head. This is what I've come up with so far.
...
Comment