-
I think it's not necessary
VituixCAD was using TLS 1.0 security protocol for downloads up to revision 2.0.100.0 (2023-03-10). That protocol was deprecated already few years ago. My service provider made some update to servers so downloads were prevented. Both newer TLS safety protocols (1.1 and 1.2) were enabled in VCAD 2.0.100.1 (2023-03-12) so downloads should work as long as TLS 1.2 is supported in web server. Some day in far future TLS 1.3 will be minimum requirement so I have to upgrade .NET Framework requirement from 4.5.2 to 4.8 to continue because 4.5.2 supports (natively) up to TLS 1.2.
Leave a comment:
-
Well, interesting- since doing a manual update earlier this week, (the first update in over a month, as I was not getting any prompts during that time, this morning I got a prompt for installing an update, in the usual manner.
I had made a mental note to myself that if auto-update prompts weren't working, I should check the change log every Sunday, on principle...Leave a comment:
-
Some more information on "how far is far enough" from Audio Precision:
Interesting. So for my 40cm (H) x 20cm (W) x 30cm (D), then M = 50cm (by pythagorean theorem).
Tomrrow I measure full polars at 1.5m. Then we merge 0-180 degree measurements taken at 1.5m, 1.0m, 0.80 m, 0.60m, 0.40m with the nearfield, and compare results!Leave a comment:
-
I wrote this document this morning, detailing a simplified process for generating off-axis data in VituixCAD. This process allows for use of measured on-axis data to generate simulated off-axis data with a good degree of accuracy. This process may be useful for "quick simulation" without the...07 August 2021, 13:58 Saturday -
This is my very first attempt at a passive crossover. Drivers are Bliesma T25B and M74B with data taken from Bliesma datasheets.
I have these drivers on order and intend to cross them actively to a pair of woofers.
Any comments? I have a few months until the drivers arrive and... -
I have been looking into upgrading the amps for my main 803Ds. These speakers do require some decent power.
I am currently using a Classe CAV-150 (6 channels X 150 watts), that I had set-up for bi-amping my front three speakers. Recently, I changed to connecting my five speakers through... -
So I was lurking and came across a schematic I don't understand.
I don't know where the positive and negative terminals would go(source). Usually I would see a ground symbol(negative) and signal generator(positive). This schematic has a circle with 2 lines coming out for... -
After trying bi-ampiming my 802Ds with a mac 402 and the Bryston 4BSST and getting great results, I was wondering if anyone out there is using the Bryston 7BSST mono blocks with the 802 speakers. The results with the mc 402 driving the mid-high and the Bryston 300amp 4BSST driving the bass drivers was...
Leave a comment: