The O-rings on my "Stand-by - Menu - Mute" buttons were dry-rotted. Takes a little time but not too difficult to change.
The power supply, the smaller transformer and a smaller board all needed to be removed (the parts outlined in blue). They need to be removed in order to make room to get a small screwdriver in there. There are two screws on the bottom of the screen board that you cannot access without removal of the listed parts. The screen needs to be removed; it will be difficult to remove/re-install the o-ring from the 'Mute' button if the screen is left in place. It will help if you have long skinny fingers like I do!
I bought some 5/16" OD x 3/16" ID o-rings at my local Ace Hardware.
If you're successful you'll end up with this!
The power supply, the smaller transformer and a smaller board all needed to be removed (the parts outlined in blue). They need to be removed in order to make room to get a small screwdriver in there. There are two screws on the bottom of the screen board that you cannot access without removal of the listed parts. The screen needs to be removed; it will be difficult to remove/re-install the o-ring from the 'Mute' button if the screen is left in place. It will help if you have long skinny fingers like I do!
I bought some 5/16" OD x 3/16" ID o-rings at my local Ace Hardware.
If you're successful you'll end up with this!
Comment