classe cp800- how do you program initial source

[tarichar]

Question: How do you program the classe cp800 to choose a certain source when it is turned on.
When I turn on the classe from stanby, itt always defaults to digital input 1 but I want it to choose analog input 1 as the default input selected from stanby.

Checked the manual and couldn't find the answer.

thanks,

troy

[fourxmotion]

My unit always remembers the last input used.

[tarichar]

For some reason, mine doesn't do that.

[wildtangent]

For some reason, mine doesn't do that.

How are you putting the CP800 into standby?

At any point do you remove the mains power from the CP800?

If you remove the mains it will perform a hard boot and wake up on source 1 which is defaulted to the USB Front. If power remains the CP800 will wake up on the last source used. This is the way all Delta products operate.

[tarichar]

Thanks so much for that.

I think that is what has been happening. Just got a new direct lines and a new electrical panel installed and have been having to turn the power off at times. I couldn't figure it out.

thanks,

troy