Hi All
It's been many years since I have posted about speaker building by my son now has an interested in the topic.
I have built a new Modula MT box that will fit in the corner of the room but when it comes to measuring the port's resonant frequency it has been nothing but frustration.
I dusted off the all wallin jig and speakerworkshop but all the results were a failure.
I can not seem to get an impedance measurement going.
So anyway what is the preferred way to get an impedance vs freq plot in order to tune the port?
I'm getting very close to just measuring the port length on the original box and using that.
It's been over 10 years and I can't remember how I got any of this stuff going. *sigh*.
Any advice would be welcome
It's been many years since I have posted about speaker building by my son now has an interested in the topic.
I have built a new Modula MT box that will fit in the corner of the room but when it comes to measuring the port's resonant frequency it has been nothing but frustration.
I dusted off the all wallin jig and speakerworkshop but all the results were a failure.
I can not seem to get an impedance measurement going.
So anyway what is the preferred way to get an impedance vs freq plot in order to tune the port?
I'm getting very close to just measuring the port length on the original box and using that.
It's been over 10 years and I can't remember how I got any of this stuff going. *sigh*.
Any advice would be welcome
Comment