Hello
Well I finally decided on a DIY Ht speaker system: Audax HT.
Since at this time, as always, money talks, so I would like to change the sealed surround speaker to a vented design.
This is what I came up with using Unibox:
20.5L with a 3" by 8.5" long port.
It was a sealed 11L before.
So without redesigning the crossover,can this be done?
Here is the link to the original speaker specs:http://www.solen.ca/audsrd.htm
It is the Audax surround speaker.
Thanks in advance...
Dean
BTW I will build the Audax fronts if this is not possible...
EDIT:
I will be keeping the same baffle width as well as tweeter/woofer placement on baffle plus tweeter to top of baffle placement.
Well I finally decided on a DIY Ht speaker system: Audax HT.
Since at this time, as always, money talks, so I would like to change the sealed surround speaker to a vented design.
This is what I came up with using Unibox:
20.5L with a 3" by 8.5" long port.
It was a sealed 11L before.
So without redesigning the crossover,can this be done?
Here is the link to the original speaker specs:http://www.solen.ca/audsrd.htm
It is the Audax surround speaker.
Thanks in advance...
Dean
BTW I will build the Audax fronts if this is not possible...
EDIT:
I will be keeping the same baffle width as well as tweeter/woofer placement on baffle plus tweeter to top of baffle placement.
Comment