like the title says this is my first speaker from the ground up, i have built a few of other peoples speaker designs and i wanted to learn to do my own. Im hoping to get some feedback on the process if i did it correctly and the design if it looks ok. i built the boxes a few years ago so i don't have any pics of them being put together they are .5 cubic ft tuned to around 32hz. I used OmniMic v2 to measure the drivers i didn't do a near-field measurement so in the pictures below 500-600hz isn't accurate. then i extracted minimum phase. i used xsim for the crossover, i couldn't get the graphs to line up perfectly while trying to figure out the offset, the picture shows as close as i could get it.
Anarchy and rs28f m/t my first speaker design
Collapse
This topic is closed.
X
X
-
Hmm, I can't look at your images closer, once you load them in a group, you have to actually put them in an image item, copying the attachment link.
I'm headed out of the country for a week on business Friday, but should be able to look at these when I'm back- if you can get them displayed properly you'll probably get comments from others.
Thanks for sharing, and hope your build works out to your satisfaction! :Tthe AudioWorx
Natalie P
M8ta
Modula Neo DCC
Modula MT XE
Modula Xtreme
Isiris
Wavecor Ardent
SMJ
Minerva Monitor
Calliope
Ardent D
In Development...
Isiris Mk II updates- in final test stage!
Obi-Wan
Saint-Saƫns Symphonique/AKA SMJ-40
Modula PWB
Calliope CC Supreme
Natalie P Ultra
Natalie P Supreme
Janus BP1 Sub
Resistance is not futile, it is Volts divided by Amperes...
Just ask Mr. Ohm....- Bottom
-
- Bottom
Comment
-
I'm looking forward to following this process as well! I have some projects for the summer which will be my first foray into designing crossovers and will need all the help I can get from the gurus here!
Great driver choices by the way, looking forward to seeing these come together.- Bottom
Comment
Comment