I am going to be building inwall surrounds for my theater setup. I will be using the following components in a 2-way design. I need help in designing a crossover and was wondering if someone could help. These will only be used for surround speakers only. Also I am open to different components and want to limit my budget to around $200-300.
Dayton Audio DC28F-8 1-1/8" Silk Dome Tweeter
Part # 275-070
Resonant Frequency (Fs)637.2 Hz
DC Resistance (Re)5.50 ohms
Voice Coil Inductance (Le)0.09 mH
Mechanical Q (Qms)0.82
Electromagnetic Q (Qes)0.90
Total Q (Qts)0.43
Dayton Audio ND140-4 5-1/4" Aluminum Cone Midbass Driver 4 Ohm
Part # 290-216
Resonant Frequency (Fs)54 Hz
DC Resistance (Re)3.7 ohms
Voice Coil Inductance (Le)0.72 mH
Mechanical Q (Qms)6.59
Electromagnetic Q (Qes)0.74
Total Q (Qts)0.66
Compliance Equivalent Volume (Vas)0.36 ft.³
Mechanical Compliance of Suspension (Cms)0.97 mm/N
BL Product (BL)3.9 Tm
Diaphragm Mass Inc. Airload (Mms)9g
Maximum Linear Excursion (Xmax)4 mm
Surface Area of Cone (Sd)86.6 cm²
Read more: .............Link to identical post on another forum removed by moderator
Dayton Audio DC28F-8 1-1/8" Silk Dome Tweeter
Part # 275-070
Resonant Frequency (Fs)637.2 Hz
DC Resistance (Re)5.50 ohms
Voice Coil Inductance (Le)0.09 mH
Mechanical Q (Qms)0.82
Electromagnetic Q (Qes)0.90
Total Q (Qts)0.43
Dayton Audio ND140-4 5-1/4" Aluminum Cone Midbass Driver 4 Ohm
Part # 290-216
Resonant Frequency (Fs)54 Hz
DC Resistance (Re)3.7 ohms
Voice Coil Inductance (Le)0.72 mH
Mechanical Q (Qms)6.59
Electromagnetic Q (Qes)0.74
Total Q (Qts)0.66
Compliance Equivalent Volume (Vas)0.36 ft.³
Mechanical Compliance of Suspension (Cms)0.97 mm/N
BL Product (BL)3.9 Tm
Diaphragm Mass Inc. Airload (Mms)9g
Maximum Linear Excursion (Xmax)4 mm
Surface Area of Cone (Sd)86.6 cm²
Read more: .............Link to identical post on another forum removed by moderator
Comment