Tweet
i am going to build natalie p's with the silk tweeter and a rss265hf under each, powered with plate amps. should i modify the crossover in any way, maybe high pass, because of the subs?
thanks
thanks
-
-
The plate amps should have a built-in crossover
IB subwoofer FAQ page
"Complicated equipment and light reflectors and various other items of hardware are enough, to my mind, to prevent the birdie from coming out." ...... Henri Cartier-Bresson -
should i modify the nat p crossover to decrease the low freq demand on the woofers?Comment
-
It woulds probably be better to build them sealed instead, which would limit the cone motion in the bottom end some and roll them off. Then tune the plate sub crossover for the flattest combined response.
Mit fruendlichen grussen vom Austria,the AudioWorx
Natalie P
M8ta
Modula Neo DCC
Modula MT XE
Modula Xtreme
Isiris
Wavecor Ardent
SMJ
Minerva Monitor
Calliope
Ardent D
In Development...
Isiris Mk II updates- in final test stage!
Obi-Wan
Saint-Saëns Symphonique/AKA SMJ-40
Modula PWB
Calliope CC Supreme
Natalie P Ultra
Natalie P Supreme
Janus BP1 Sub
Resistance is not futile, it is Volts divided by Amperes...
Just ask Mr. Ohm....Comment
-
ok thanks, what size box for the natalie p?
thanksComment
-
Build them as the standard 1 cu. ft. size. Just build them sealed instead of ported and use the normal Nat P crossover. That is what I did with mine.
I have my Nat P's on top of Bass Bins and am using an active crossover from the Nat P's to the Bass Bins.Comment
-
thats what i'll do also. my L4 is .47mh not .44mh, how much should i unwined if any?
thanksComment
Comment