CJD Dayton RS Crossover BOM

[joeybutts]

So I was reading over the thread and was studying the crossover and wanted to get a BOM for the center. A lot of questions arose, that I think can be answered by just listing the parts. I was wondering if I am overdoing some parts,

One big question I had was that some of the inductors weren't in millihenries, they were in microhenries I believe. Do these need to be custom wound?

BOM

Woofer Section
255-432 Jantzen 2.2mh 15 Awg
027-447 Dayton 100uf Poly Cap
027-442 Dayton 40uf Poly Cap
005-3 Mills 3 Ohm Resistor

Mid Section
027-432 Dayton 15uf Poly Cap (this with the 20uf are for the 35uf)
027-436 Dayton 20 uf poly Cap
255-634 Jantzen 1.3mh 16 Awg
255-436 Jantzen 3.0mh 15 Awg
266-330 .6mh 14 Awg
027-578 Solen 16uf Poly Cap
027-430 Dayton 12uf Poly Cap
005-6 Mills 6 ohm Resistor


Tweeter Section
027-434 Dayton 18uf Poly Cap x2 (one for the 21uf with one of the 3uf)
027-418 Dayton 3uf Poly cap x2
027-442 Dayton 40uf Poly Cap
027-449 Dayton 68uf Poly Cap
255-436 Jantzen 1.3mh 16 Awg
266-345 .9mh 14 Awg
255-208 Jantzen .18 18 awg
005-6 Mills 6 ohm Resistor
005-10 Mills 10 ohm Resistor

Thanks for the double check and letting me know if certain things can be downgraded. :T

[joeybutts]

Is a 600 uh actually a .6mh?

[---k---]

I found a BOM with all of the PE part numbers somewhere. I copied it the first post of the Khancenter thread. Did you check this against that?

[joeybutts]

I found a BOM with all of the PE part numbers somewhere. It is in the Khancenter thread. Did you check this against that?

Nope but will check it out now! Thanks Ryan.

EDIT: Correct you are! Thanks!!!