For Sunosub III, I've decided to go with a round table top look. I'm not quite sure if I'm doing the wetsanding correctly, but here goes:
1. Clean off the top's surface.
2. Spray paint the top with black paint.
3. Wet sand for smoothness and little bits of debris removal.
4. Clean off the top's surface.
5. Apply clear lacquer.
Once the lacquer dries, I get paint brush streaks.
6. Wet sand the lacquer layer for smoothness. I guess this is the time-consuming part because of the brush streaks, it's really tough to get the surface really smooth again.
And then I'll be repeating steps 1-6 all over again.
Am I doing this right before I get to the final coat of paint and then I'll be using a polycrylic clear coat to seal it.
PatCave; HT Pix;Gear;DIY Projects;DVDs; LDs
1. Clean off the top's surface.
2. Spray paint the top with black paint.
3. Wet sand for smoothness and little bits of debris removal.
4. Clean off the top's surface.
5. Apply clear lacquer.
Once the lacquer dries, I get paint brush streaks.
6. Wet sand the lacquer layer for smoothness. I guess this is the time-consuming part because of the brush streaks, it's really tough to get the surface really smooth again.
And then I'll be repeating steps 1-6 all over again.
Am I doing this right before I get to the final coat of paint and then I'll be using a polycrylic clear coat to seal it.
PatCave; HT Pix;Gear;DIY Projects;DVDs; LDs
Comment