I have been lurking here fo a couple of years now and would like to learn to design too. PE has some peerless and Vifa drivers on sale and I have been reading good things about them over at the PE board. In general I know that poly and paper cones are easier to work with due to the self damping properties of the cone.
I don't have any measurement equipment yet, but planning to purchase in the future.
My plan is for a 2 way system.
Would like to get some opinions about these:
Woofers:
I tend towards the 6.5" HDS.
Tweeters:
Questions/help:
I would like to design an MTM, would an MT be much easier?
Any input/suggestions on driver selection would be great.
This will be a slow process for me (since my life is very bussy at the moment), but I rather do it slowly then delay it for a couple of years.
Thanks,
Asi.
I don't have any measurement equipment yet, but planning to purchase in the future.
My plan is for a 2 way system.
Would like to get some opinions about these:
Woofers:
I tend towards the 6.5" HDS.
Tweeters:
Questions/help:
I would like to design an MTM, would an MT be much easier?
Any input/suggestions on driver selection would be great.
This will be a slow process for me (since my life is very bussy at the moment), but I rather do it slowly then delay it for a couple of years.
Thanks,
Asi.
Comment