Hello! It's been a while since I've posted, but I was hoping I could get some feedback on the Sonosub design I have come up with.
I have a single 12" Shiva and will be pushing it with an Adcom GFA-545 amp. My room is 16' x 24' with a vault along one long wall and one short wall.
The room is not setup idealy, as my entertainment system is against the long wall with the vault. The rear of the room is pretty wide open with a hallway, kitchen, and dining area.
I don't remember how I came up with these dimensions, but here is what I have:
18" diameter sonotube with the internal height being 40.5" and a single 15.35" long 4" flared port. This yields a volume of 160 liters, or 5.65 ft^3.
Will this work? I'm picking up the sonotube tomorrow and will start putting it all together; but would like some verification that my plans are sound. If not, what adjustments should I make?
Thanks to all,
Thomas.
I have a single 12" Shiva and will be pushing it with an Adcom GFA-545 amp. My room is 16' x 24' with a vault along one long wall and one short wall.
The room is not setup idealy, as my entertainment system is against the long wall with the vault. The rear of the room is pretty wide open with a hallway, kitchen, and dining area.
I don't remember how I came up with these dimensions, but here is what I have:
18" diameter sonotube with the internal height being 40.5" and a single 15.35" long 4" flared port. This yields a volume of 160 liters, or 5.65 ft^3.
Will this work? I'm picking up the sonotube tomorrow and will start putting it all together; but would like some verification that my plans are sound. If not, what adjustments should I make?
Thanks to all,
Thomas.
Comment