As most of you know I have been wanting to build a sub for a while now and was posed for the sono. Since then, I have played with the idea of a sub box that is 24"w x 20"h x 20.3"d. that would give me the same volume as the Sono I was designing (130L). The driver is to be placed along the 24" width with the port on the same baffle face.
What are some general guide lines to bracing this box internally?
Should the bracing run parrallel to the baffle or perpendicular, does it matter?
What should the general spacing be?
I was planning on using 3/4 MDF, should I step up to 1" instead?
What is the easiest and simplest cut out to use on the bracing to calculate volume displacement? i.e. a circle would be the simplest in my mind but leaves too much material in the brace.
Bing
What are some general guide lines to bracing this box internally?
Should the bracing run parrallel to the baffle or perpendicular, does it matter?
What should the general spacing be?
I was planning on using 3/4 MDF, should I step up to 1" instead?
What is the easiest and simplest cut out to use on the bracing to calculate volume displacement? i.e. a circle would be the simplest in my mind but leaves too much material in the brace.
Bing
Comment