Hey guys....
Im good with coming up with ideas, but the technical part is where I am lacking right now... graphs, charts, imps, freqs.... yea... mm hmmm.
I have been reading DIY speaker forums for over a year now.... I have gotten somethings down pat, but other things im still lacking in.... namely because I can't seem to get speaker workshop to work correctly... and i've given up LOL
so, I came here.... groveling.... looking for help with my idea, so if someone, anyone can chime in and help a stuck DIY'er and offer assistance please??
Idea....
Highs 1 per - Dayton PT2C-8
Mid 2 per - Dayton RS150S-8 6"
Lowend 1 per - Dayton RS270S-8 10" (down firing + ported)
So a 3-way design using those drivers... and I was planning on "stealing" the x-over design from the WMTW since it also uses the RS150-8 ohm driver.... but I wasnt sure on how it would work with 2 of them in 1 cabinet on the same x-over.... would this be a problem?
Second.. Im not even sure on the cross point on the PT2 and how well this works with the RS150...
Third... the 10"... another hurdle to work out with the freq resp.
advice? lol.....
This is a project in the making.......
Im good with coming up with ideas, but the technical part is where I am lacking right now... graphs, charts, imps, freqs.... yea... mm hmmm.
I have been reading DIY speaker forums for over a year now.... I have gotten somethings down pat, but other things im still lacking in.... namely because I can't seem to get speaker workshop to work correctly... and i've given up LOL
so, I came here.... groveling.... looking for help with my idea, so if someone, anyone can chime in and help a stuck DIY'er and offer assistance please??
Idea....
Highs 1 per - Dayton PT2C-8
Mid 2 per - Dayton RS150S-8 6"
Lowend 1 per - Dayton RS270S-8 10" (down firing + ported)
So a 3-way design using those drivers... and I was planning on "stealing" the x-over design from the WMTW since it also uses the RS150-8 ohm driver.... but I wasnt sure on how it would work with 2 of them in 1 cabinet on the same x-over.... would this be a problem?
Second.. Im not even sure on the cross point on the PT2 and how well this works with the RS150...
Third... the 10"... another hurdle to work out with the freq resp.
advice? lol.....
This is a project in the making.......
Comment