Does anyone have schematics for BMS 4540ND (anywhere from 1200hz on up) for a 2 ways setup. I can tune my low frequency drivers to match the 4540nd. Thanks.
Crossover for BMS 4540ND
Collapse
This topic is closed.
X
X
-
The only usage of the BMS4540 on this board with a passive crossover is in the three way Isiris system, used with a DDS waveguide. Note that due to the complex impedance of a horn driver and waveguide within the driver operating range, a muli-part zobel is recommended for a passive crossover, otherwise the impedance variations put ripples in the frequency response.the AudioWorx
Natalie P
M8ta
Modula Neo DCC
Modula MT XE
Modula Xtreme
Isiris
Wavecor Ardent
SMJ
Minerva Monitor
Calliope
Ardent D
In Development...
Isiris Mk II updates- in final test stage!
Obi-Wan
Saint-Saƫns Symphonique/AKA SMJ-40
Modula PWB
Calliope CC Supreme
Natalie P Ultra
Natalie P Supreme
Janus BP1 Sub
Resistance is not futile, it is Volts divided by Amperes...
Just ask Mr. Ohm....- Bottom
Comment