croosover building ???

[yousuredo2]

I am in the process of building my nat P's crossover and need to make sure I am doing it correctly.

I am going by Opt-e pic. and in some places more than one wire intersect another.
- Is it ok to conect all at the same place, if not how far apart do they need to be ?
- the inductors have an inside & outside wire conection, does it matter witch direction it is wired ?
- is anything directional in this crossover ?

[Landroval]

1) It is ok
2) Doesn't matter
3) No

[opt-e]

Nice to see my crossover diagram is getting some good use 8)

[Dean100]

Opt-e, Your picture along with a couple of others was a great help to me when I built the crossovers for my Nat's. Thank you! :T

[wkhanna]

Me, too!
Thanks for letting us use it.

[opt-e]

Sometimes it feels like all I do is leech from the forum. With no knowledge of electronics nor experience in woodworking, it's nice to be able to give a little back :T

[geno742]

I used your posts as a guide when I built my Nat P's with great success due to the clear pics and diagrams

They really do sound great!

[yousuredo2]

Heck Yah, thanx for the info...

Opt-e ~
thanks a ton for it. it is helping me along the way with my first attempt at crossovers.

[yousuredo2]

~one more dumb question...
I have connected a resister before the 2 paralleled caps connect... I dont know what i was thinking. Just got into the grove and slipped right by that...

this is a NO No, Yes

[opt-e]

As far as I know, this is just fine. But don't take my word for it, I'm a software developer not an electrical engineer ops: 8)

[wkhanna]

If I am interpreting your pic correctly, you have no worries.

[ThomasW]

We're not psychic.... :roll:

You reposted Opt-e's picture not a picture of your crossover. And you didn't identify what specific components you're talking about. So it's impossible to know what you did, or it's effects.

[yousuredo2]

I crop & reposted it, with modifications at R8 & C10(red line-Bright green line)

[ThomasW]

Doing that's not a problem...