Tweet
Good evening,
I have probably a really dumb question on the best way to stuff polyfill in the sub I am building. I am building the Adire alignment sub from the plans from the Acoustic Visions site. In the instructions it states to stuff the cabinet with 64oz of polyfill stuffing. I purchased 4 1# bags of the polyfill from PE and I am ready to get it done. I have read here and in other forums that most use spray glue and glue the stuffing to the inside walls of the cabinet, after laying out the polyfill from the 4 bags it does not appear to be enough to cover the entire inside surface. Is there a better way to do this, Would it change the tuning much to add a # or 2 more stuffing to get the inside walls completely covered? See, I said it was a dumb question. But any and all suggestions would be greatly appreciated.
Regards, Ed
I have probably a really dumb question on the best way to stuff polyfill in the sub I am building. I am building the Adire alignment sub from the plans from the Acoustic Visions site. In the instructions it states to stuff the cabinet with 64oz of polyfill stuffing. I purchased 4 1# bags of the polyfill from PE and I am ready to get it done. I have read here and in other forums that most use spray glue and glue the stuffing to the inside walls of the cabinet, after laying out the polyfill from the 4 bags it does not appear to be enough to cover the entire inside surface. Is there a better way to do this, Would it change the tuning much to add a # or 2 more stuffing to get the inside walls completely covered? See, I said it was a dumb question. But any and all suggestions would be greatly appreciated.
Regards, Ed
Comment