I just orderd an OEM10 from TC sounds and 2 of the matching PR's. I tried to get help on their boards and doesn't seem to be working out so well. I'm running it with a Crown XTI 1000. Here are the parameters for the sub
TSP's
Qts 0.357
Qes 0.400
Qms 3.35
Fs 30Hz
Res 3.11 ohms
Ls 4.0 mH
Lp 6.26 mH
Rp 9.9 ohms
Dia 208mm
Vas 19.3 liters
Mms 224 grams
Cms 119 um/N
BL 18.35Tm
Spl 83.3dB
They don't list SD or LE though. Also they don't seem to have the T/S's for the PR's not sure if its needed? It's a 10" driver same for the PR's. I'm running linux and can't seem to get unibox to work in openoffice correctly. I would like the PR's tuned to 20hz so I'm trying to find out how big the enclosure needs to be (I'm guessing around .5 cu ft) and how much weight to add to the PR's.
Thanks in advance!
In case you need any of this these are the specs.
OEM overstock TC-10.
Lightweight Honeycomb glass fiber cone
1" tall NBR surround
28mm xmax
190 ounce motor
800 watts RMS
3" wide, long-wind AL voice coil
Dual 8.5" spiders with woven leads
Single 4 ohm DCR or Dual 4 ohm DCR
Actual weight: 29.5 pounds
TSP's
Qts 0.357
Qes 0.400
Qms 3.35
Fs 30Hz
Res 3.11 ohms
Ls 4.0 mH
Lp 6.26 mH
Rp 9.9 ohms
Dia 208mm
Vas 19.3 liters
Mms 224 grams
Cms 119 um/N
BL 18.35Tm
Spl 83.3dB
They don't list SD or LE though. Also they don't seem to have the T/S's for the PR's not sure if its needed? It's a 10" driver same for the PR's. I'm running linux and can't seem to get unibox to work in openoffice correctly. I would like the PR's tuned to 20hz so I'm trying to find out how big the enclosure needs to be (I'm guessing around .5 cu ft) and how much weight to add to the PR's.
Thanks in advance!
In case you need any of this these are the specs.
OEM overstock TC-10.
Lightweight Honeycomb glass fiber cone
1" tall NBR surround
28mm xmax
190 ounce motor
800 watts RMS
3" wide, long-wind AL voice coil
Dual 8.5" spiders with woven leads
Single 4 ohm DCR or Dual 4 ohm DCR
Actual weight: 29.5 pounds
Comment